Flametec™ CP7-D Typical Properties

Property	Units	Value⁽¹⁾	ASTM Method
Physical
Density @ 23°C	g/cm³	1.38	D 792
Mechanical
Tensile Strength	psi	2500	D 638
Elongation at Yield	%	4.0	D 638
Flex Modulus	psi	450,000	D 790
Izod Impact (notched 1/8 in.)	ft-lb/in	10.1	D 256
Hardness (Shore D)	10 sec.	67	D 785
Corner Weld Strength	lbs/linear inch	467	CPC Test
Thermal
Heat Deflection temperature	66 psi	248°F	D 648
Vicat Softening Point	1 kg	299 Deg. F	D 1525
Flammability
Factory Mutual	FPI	<4.2*	File #3D7Q7.AM
Factory Mutual	SDI	<0.01*
Flammability Rating	ETL Labs	V-0	per UL 94 Test
Flammability Rating	ETL Labs	5VA	per UL 94 Test
Flammability Rating	ETL Labs	<25 flame	E84 Tunnel Test
Flammability Rating	ETL Labs	<100 smoke	Meets Class A

* FPI, SDI all FMRC test data

¹ Physical properties of plastic sheeting are represented as "Typical". Information contained herein is considered accurate to the best of our knowledge. It is offered for your consideration and investigation, and is not to be construed as a representation or warranty expressed or implied. Our warranties are limited to those expressly stated in formal contracts or in conditions of sale on our invoices and order acceptances. Conditions and methods of use may vary and are beyond the control of Compression Polymers Corp., therefore, Compression Polymers Corp. disclaims any liability incurred as a result of the use of this product in accordance with the data contained in our physical property charts. No information herein shall be construed as an offer of indemnity for infringement or as a recommendation to use the products in such a manner as to infringe any patent, domestic or foreign.

The "Typical" properties of our plastic sheet cannot be automatically used when engineering finished component, and the fabricator or end user is responsible for insuring the suitability of our products for their specific application or end use!